The Makita DPC6410 12" power cutter offers a fresh new design that enhances performance and provides greater operator comfort.
This 64cc Cenet saw is loaded with new technological innovations such as the micro-chip controlled carburetor that compensates engine timing to work load.
The new and improved 5-stage air filtration system has been enlarged by 80% to ensure cleaner air for better performance, even in the dustiest conditions.
Better filtration means less down time for maintenance and more production time.
Makita also beefed up the aluminum blade guard with pressure plates for reduced vibration and wear.
The DPC6410 is equipped with a spring tensioned belt adjustment w/gauge to always ensure proper belt tensioning.
Compression release, single knob access to primary air filter and spark plug and a 2-mass dampening system for reduced vibrations makes this the industry leader when it comes to Power Cut saws. You expect the best from Makita - and you get it.
Features
Five-stage, foam-paper-nylon system with Advanced Directional Air Flow provides very clean air for better saw performance
Reinforced aluminum blade guard with 70° range of limitless positioning using a marked knob handle
Improved ignition system with larger flywheel and rare earth magnets for more power
Cutting arm position simply changes from center position to flush (outboard) position allowing cuts directly adjacent to curb edges, walls or directly above the ground
Starter grip and decompression valve located on the same side for faster starting
On-Off-Choke operating switch on a single lever for operator convenience
Cushioned operator grips with 4 vibration-absorption rubber buffers for increased operator comfort
Water kit is assembled to saw and can be used with garden hose, gravity tank or pressure tank
Improved exhaust emissions are EPA Phase II compliant while maintaining power and performance
.gif)
.gif)
.jpg)
.jpg)
.jpg)
