TheToolStore.ca | M-Power Flat Lying Trammel Head Set – Tri Scribes Only $22.99

Description: 

• Need to draw a circle? or rather… Need to draw an accurate circle? One where the finishing point actually meets the starting point? M.POWER’s Flat Lying Trammel Head Set will guarantee you exactly that.
• Simply clip the two Trammel Scribe heads onto any length of steel or Aluminium Rule from 6 inch to 6 feet in length.
• Choose the pencil or the hyper fine cutting blade and strike that arc.

Features:

• Hands Free Stability
• Flat Lying positioning
• Self supporting assembly
• Quick setting “Lock and release
• Utilizes either a steel or Aluminium shop rule
• Low centre of gravity
• Virtually unlimited radii
• Versatile - Acts deep range marking gauge
• Versatile - Acts as a Mortise Gauge
• Work to a Pencil line or a hyper fine cut-line

Contents:

2 x Quality die cast electro coated trammel heads
1 x Carbon steel pivot point for durability
1 x Pre-set angled steel blade Post
6 x replacement blade segments
1 x Allan key
1 x “H” Pencil

Clip a scribe head onto a Tri Square or Engineer square to strike a parallel line to rival the accuracy of any high quality marking gauge.

BLADE KIT – TRI BLADE

The FLTS includes a blade post and a bar of replaceable blades allowing you to strike a hyper fine line. Used when set up as a trammel compass and accurate circles can be cut out in veneer, light card and paper.

Large and Small Circle Marking

M.POWER’s heads attach to any standard steel or aluminum rule; hence, the size of the radius you can mark is only limited by the length of your rule. Simply lock one scribe unit in place, measure out the required radius between the scribe point and pencil point and lock the second scribe unit. 

Marking Gauge

Add a Tri-Scribe unit to a standard try-square or combination square transforms it into a very accurate and stable marking gauge because the forces in the marking unit are now parallel instead of perpendicular. Since the trammel heads will hold your choice of a scribe, pencil or blade, it is a both a marking and cutting tool, versatile, accurate, and simple to use.

Mortise Gauge

Attach both Scribe heads to your try-square or combination square as a mortise gauge. Again the strengths of this over a traditional gauge hold true, offering increased stability, accuracy and ease.

Cutting Gauge

The Blade post is included in the kit and creates a cutting gauge that can cut parallel lines and circles. Ideal for trimming veneers and cards precisely, the Tri-Blade also allows very fine and accurate marking lines to be cut.