Blackjack, 17512 2 1/2 Bench Dog Clamp Hold Down 14424
One of the handiest tools to have around the workbench is a set of bench dogs.
They allow you to clamp material between the dog on your woodworking vice and any point over the top of the bench where you have 3/4” diameter bench dog holes drilled.
These are short bench dogs (2-1/2") because most benches made today have tops only 1” or so thick.
If your work bench dosen't have pre-drilled holes simple add the 3/4'' hole as needed. Drilling the with a hand drill is fine but for best results use a 3/4'' up spiral bit in a plunge router. This produces straight a accurate holes